EASYJOINT™ 60 Setting Type Premium Jointing Powder

• Consistent setting time
• Mixes easily to a smooth and creamy gauge
• Easy scrape back
• Excellent joint filling with excellent adhesion, high strength and low shrinkage

EASYJOINT™ 60 Setting Type Premium Jointing Powder application

• Surfaces must be clean and free from dust
• The use of paper tape is recommended such as USG Middle East Paper Joint Tape
• Ensure there is sufficient amount of compound under the paper tape to provide adhesion
• First Coat (150mm wide)
  • Using a broad knife, evenly fill the joint recess formed by the edges of the gypsum board with EASYJOINT™ 60 Setting-Type Premium-Jointing Powder
  • Center paper tape along the joint and press into the compound using the broad knife
  • Draw the broad knife at a 45° angle along the joint with enough pressure to remove excess compound and any air bubbles caught beneath the tape. Leave enough compound under the tape to provide a strong bond
  • Apply a thin layer of compound over the tape to prevent the tape edge curling and cracking. Feather the compound from the edges outwards. Cover all fastener heads with spots of compound
• Second Coat (200mm wide)
  • When dry, apply a second coat using a plasterer’s trowel, approximately 50mm wider than the first coat. Spot fastener heads again. Allow to dry
  • When the second coat has dried, scrape or sand back any excess compound for a smooth and level surface
• Third Coat (250mm wide)
  • Apply a finishing coat of compound with a trowel, approximately 50mm wider than the previous coat
  • When dry, using 180 to 220 grit sandpaper in a hand sander, sand lightly to a smooth finish, taking care not to scuff the surrounding gypsum board
  • Thoroughly clean all tools and equipment after use